1. BaSaMa & HiWi
    2.  

Design and Commissioning of a Pressure Regulator for a Nanosatellite Propulsion System

Institut
Lehrstuhl für Raumfahrtantriebe (TUM-ED)
Typ
Masterarbeit /
Inhalt
 
Beschreibung

Water Electrolysis Propulsion (WEP) Systems produce gaseous propellants in-orbit by decomposing stored water into Hydrogen and Oxygen using an electrolyser. This allows water to be used as a safe and green propellant, while delivering higher pefromance compared to conventional hydrazine propulsion systems.

The generated gaseous propellants are stored in high-pressure, compact intermediate tanks. Directly feeding these to the downstream hot- and cold-gas thrusters would result in considerable performance variation during blowdown operation and place strict requirements on downstream component selection. This can be avoided by regulating the tank pressure down to a defined constant operating pressure.

Such a pressure regulation unit must be light and compact in order to justify its implementation in a CubeSat-scale propulsion system. Previous trade-off studies identified the both the use of a commercial off-the-shelf (COTS) pressure regulator and implementation of bang-bang pressure regulation using a solenoid valve as promising options.

The aim of this project is to implement and compare both options within the Ice2Thrust WEP testbench. For the bang-bang regulation, this requires the derivation of a control strategy suitable for all operating conditions, while for the COTS component a characterisation of its performance envelope is required.

 

Tasks

  • Familiarisation with with the Ice2Thrust testbench hardware and layout
  • Proposal of control strategies and hardware for bang-bang pressure regulation with specified solenoid valve (Lee IEP) and pressure sensor (Kulite XTEL-140)
  • Transient validation of bang-bang control strategy using 1D simulation
  • Hardware implementation and commissioning of a bang-bang and COTS pressure regulator as part of the Ice2Thrust testbench
  • Proposal and execution (with supervision) of test blans to vlaidate both approaches
  • Definition, and if possible, implementation of control strategy on representative flight hardware.

 

Deliverables

  • Implemented COTS pressure regulated fluid branch
  • Implemented bang-bang pressure regulated fluid branch
  • Report with hardware-validated comparison of both approaches
Voraussetzungen
  • Student in Aerospace or Mechanical Engineering.
  • Experience with and demonstrated interest in hardware assembly and testing is a plus.
  • Experience with electrical or data acquisition hardware and software is a plus.
Möglicher Beginn
sofort
Kontakt
Tomas Mrazek, M.Eng.
Tel.: +33695349960
tomas.mrazektum.de
Ausschreibung